[davidescu76]

Hi !
Can anybody explain me, please, why always my 3d reliefs looks like fluffy ONLY in the left side of model? See photo.
I used tapered ballnose, 1 mm .
I tried to change in Artcam raster angle many times but same (traces, fluffy, trails) effect, i also change wood piece pozition vertical and horizontal, a lot of combinations of feeds and speeds.... same bullcake
What to do? It is possible that my spindle is not perfectly perpendicular to the table?
Thank you !

[Roque7]

This occurs when the ballnose gets the grain against the grain. I think we all do.The solution, sand.
Sorry for the bad translation, with an automatic translator.

[davidescu76]

Gracias! Thank you! But why not happened in both sides? Always in left side and never right side. For example, if i carve a hemisphere, only left side, like a little moon it occurs fluffy.

[awerby]

Different wood species react differently to rotary cutting. What are you using? It's common to get that "fur" on one side of your cuts. Have you tried all-climb, or all-conventional instead of a meandering cut? Sharper tools do this less.

[ger21]

Use a harder wood and cut along the grain.