Need Help,
We have Okuma & Howa Twin Spindle 4 Axes Lathe that lost all parameters due to bad batteries. I have restore the parameters, program and wear offset. The problem is G01 won't run in single block mode
G40 G28 U0 W0 T0 ;
N1 T400 M8 ;
G0 G50 X188.3 Z37.5 M8 ;
G0 Z1. ;
X25. T2 G97 S3200 M03 ;
G1 X-1.2 F0.35 ; (no movement here)
etc
I'm not sure that 900 parameters are correct, I don't backup them since I forget to press EOB when transferring to PC so I write them down
here are the parameters
900 00111000
901 11110000
902 00000100
903 00000000
904 00000000
905 00000001
906 11101000
907 01010000
908 00000000
: :
939 00000000
Your help will be sincerely appreciated.
Best regards,
galih