[Tomeeii]

Dear Boss,

I have next problem: when i try change the tools the procedure is start well, but when the Z axis must be go up 3.8inch the machine is go to emergency mode.
The z axis all time go up just 34-35mm and tools half in the spindle and half is in atc. The machine was resetted total (battery removed from cpu card)
in setp menu i adjusted evrything . (i hope).
air we have enough,
Have u idea what was wrong?
MAchine is fadal 3016l with cnc88 hs.
The z servo was removed too .

ThanksTomee

[denmar]

check switch inside tool in out assambly

[Tomeeii]

i find the problem, it was one wrong settings in setp menu.
Now its works fine.

Thanks

[dardo]

Hello Tomeeii
I have the same problem, can you tell me what was your solution?

Thank you

Greetings.

[Tomeeii]

Hello Tomeeii
I have the same problem, can you tell me what was your solution?

Thank you

Greetings.

Sure, it was wrong setting in setp menu.
I will check for u what was. Here is my private email: [email protected]

Send me your email.

Thanks