thank u so much guyz for ur support nd time.
u see there are some NC Basic files that let us enter the parameters,but unfortunately these have been deleted,nd have disabled all keys
SRAM256.FDB is the type of file required along with files like PMC0BSC etc.
if anyone has got these files or has a fanuc control,plz send me these files,plz,my whole carrier depends on it!
Thread: "Fanuc 21i-TA"
Results 1 to 4 of 4
-
09-07-2024, 08:06 AM #1
- Join Date
- Aug 2024
- Posts
- 3
"Fanuc 21i-TA"
-
09-07-2024, 05:51 PM #2
Member
- Join Date
- Dec 2009
- Posts
- 1003
Re: "Fanuc 21i-TA"
SRAM contains all the data for your specific machine so we need to know the name of the machine and type
You can not load a SRAM from milling to a lathe or vice versa
Also for basic files must show the serial number of the controller-you can find the Fanuc label on the back of the controller
The serial number start with : E XXXXXX
-
09-08-2024, 05:22 AM #3
- Join Date
- Aug 2024
- Posts
- 3
Re: "Fanuc 21i-TA"
Serial number of the controller is : E013A0449
-
09-09-2024, 05:37 AM #4
Member
- Join Date
- Dec 2009
- Posts
- 1003
Re: "Fanuc 21i-TA"
as i see we talking about 600 Lathes machine
what model and type is this lathe?
what files you need for it?
Reply With QuoteSimilar Threads
-
How can do ""manual stepper motor sizing for "rack and pinion"calculation""???
By Medhat93 in forum Mechanical Calculations/Engineering DesignReplies: 0Last Post: 03-03-2018, 01:50 AM -
Fanuc Retrofit - What are "OP" "R11" "S11" etc
By eriksalo in forum FanucReplies: 4Last Post: 02-23-2017, 11:26 PM -
How to remove error " Turret out of position" in Ge fanuc 21i-t controller for lathe?
By shanu4454 in forum Phase ConvertersReplies: 5Last Post: 09-22-2014, 04:05 AM -
X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"
By DaDaDaddio in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 05-06-2013, 09:59 AM
Tags for this Thread
Posting Permissions
