506,330 active members
2,515 visitors online
Register for free
Login
Results 1 to 5 of 5
  1. #1
    Registered
    Join Date
    Apr 2009
    Posts
    5

    NEED HELP!!! Fanuc OM AXIS INTERLOCK

    Recently I purchase a Supermax 1 Rebel, Changing the parameters for use a DNC software accidentally turn off the machine before restore the PWE to 0. When I restart the machine I cant move any axis and it show a massage " axis interlock". I need help! Thanks Folks!!!
    Last edited by RoblesTig275; 04-19-2017 at 05:45 PM.

  2. #2
    Registered
    Join Date
    Apr 2017
    Posts
    28

    Re: Fanuc OM AXIS INTERLOCK

    Hold "P" key and "CANCEL" at the same time, power on the control, this should remove the alarm and allow you to move the axes away from OT switch.

  3. #3
    Registered
    Join Date
    Apr 2009
    Posts
    5

    Re: Fanuc OM AXIS INTERLOCK

    Cincyice58, Thanks a lot!!! The cnc is moving again!!!

  4. #4
    Registered
    Join Date
    Apr 2017
    Posts
    28

    Re: Fanuc OM AXIS INTERLOCK

    great to here

  5. #5
    Registered
    Join Date
    May 2016
    Posts
    26

    Re: Fanuc OM AXIS INTERLOCK

    I have a supermax mill just purchased it. It came without parameters, I could read only scrambled letters and numbers. I reentered all parameters from the data sheet found.
    I have an alarm so far "operator message" 2000.
    Any ideas...

Similar Threads

  1. VTC 20c Error 128 outside interlock axis HELP PLEASE!
    By AK2015 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 0
    Last Post: 09-07-2015, 08:51 AM
  2. alarm 128 outside interlock b axis
    By mikegmoore in forum Mazak, Mitsubishi, Mazatrol
    Replies: 0
    Last Post: 07-22-2014, 12:18 PM
  3. mazak vtc-16b 128 axis interlock
    By krueg64 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 02-17-2014, 06:20 PM
  4. Safety interlock Fanuc 10M?
    By Togliatti in forum Fanuc
    Replies: 14
    Last Post: 12-02-2011, 08:03 PM
  5. Fanuc OM w/ no. 2000 axis interlock alarm
    By bikebasher in forum General CNC (Mill / Lathe) Control Software (NC)
    Replies: 0
    Last Post: 05-23-2008, 07:59 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •