Hi guys.
I have boscshrexroth indradrive and servo motor on my hand and I cant configure via Indrawoks ds software.
servo motor type: MSK100B-0200-NN-S1-BP0-NNNN
drive type: Indradrive HCS02 , CSB01.1C-SE-ENS-EN1-L1-S-NN-FW (BASIC UNIVERSAL SINGLE AXIS)
When I boot the drive via serial interface, it appeares on the display of drive P -1 Which means the drive stock in phase 0 and can not shift to phase 1 or somthing like this.
The alarm on the the Indraworks software is "A0009 Automatic baud rate detection for SERCOS interface" seems has not specific solotion in the help section of the software
And on the easy startup mode from "optimization" under "Commissioning" tab I have a "C0220" alarm
anyone can help
best regards