[rosco89]

Hi, new to forum here. just looking to see if anyone out there can help me with a amada alarm that i am coming up with.The alarm is 2202 calibration fail. the machine will do the beam alignment fine , but to do 8010 height adjustment it will go down to about 2.14" off of material then come up with the alarm. any help would be appreciated. thanks.

[Pitre]

Hi Rosco,

What is the Machine Model & Fanuc Controller Model.

based on this info.....it will be clear what type of Z-axis calibration sensor machine has.

thanks.

[rosco89]

it is a amada fo 3015 with a fanuc 160i-l. The other question I have if you could help is there a way to restart a cut after a cutting head connection alarm or a z sensor wire break alarm comes on? THANKS, ROSCO.

[AMADAJOE]

it is a amada fo 3015 with a fanuc 160i-l. The other question I have if you could help is there a way to restart a cut after a cutting head connection alarm or a z sensor wire break alarm comes on? THANKS, ROSCO.

Do you have 12vdc from nozzle to ground? could be head, short cable, HS box, long cable, HS board.