548,463 active members*
2,461 visitors online*
Register for free
Login
Results 1 to 1 of 1
  1. #1

    Meldas 520L ecoca teach in. G71 problem

    Hello.

    We Just got a old ecoca el-4610 lathe, that we finaly got running. However i am still struggeling to use it. Today i testet a simple teach in taper operation, but never managed to make it run through. It starts the spindle, advance both axis up to the workpice, but then holdes.

    Says p203 conf. Err(mrc)

    I am quite new to g-code, but can not find what is wrong. Can it be some setup in the meldas software?
    Attached Thumbnails Attached Thumbnails Screenshot_20211120_183759_com.huawei.himovie.overseas.jpg   Screenshot_20211120_183933_com.huawei.himovie.overseas.jpg  

Similar Threads

  1. ECOCA - MELDAS MAGIC 64L
    By rajesh_1355 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 3
    Last Post: 08-12-2021, 11:24 AM
  2. Doosan 200L Meldas 520L
    By inthedark in forum Daewoo/Doosan
    Replies: 1
    Last Post: 03-07-2016, 05:18 PM
  3. problem with g71
    By redfoxbody11 in forum Hyundai Kia
    Replies: 8
    Last Post: 11-12-2010, 09:00 PM
  4. Blown a meldas 520l with to much voltage
    By SQT18MS in forum Mazak, Mitsubishi, Mazatrol
    Replies: 4
    Last Post: 10-22-2008, 10:35 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •