[unisign]

Got this nice machine form Germany, the former owner had install a Vcarve pro software in German (my German is so bad)
He also chance the keypad to a china model, hard to figure out.
Would very much find an original keypad and also and original Enroute software to match.
Would like to go back to the original status for this machine.
Had 2 machines with the original software and are very satisfy with it. Are just making letters in PVC with it
Can anyone help ?

[ack1]

If the pendant is some other than original i bet the controller has been replaced aswell.

[ack1]

Ok so now im curious. Lägg gärna upp en bild på controllern så får vi se om det ens är en multicam controller. Jag har tillgång till allt en servicegubbe för multicam har så det är bara säga till om du vill att jag tar fram något. Alternativt skicka ett privatmeddelande så skickar jag telefonnummer som svar.

[mike03857]

Where are you located? I sell keypads and Enroute.