531,647 active members*
1,865 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Vectric > Need a little help
Results 1 to 1 of 1
  1. #1
    Member
    Join Date
    Oct 2014
    Posts
    5

    Need a little help

    I am new to CNC and have just made about a $5,000 investment so I am looking forward to learning more. I have been doing several test pieces and have run into something I cannot find the answer to.

    How do I cut away the waste areas to reduce the overall height near my profile cut? I am sure there is an easy way I am overlooking. I have attached a screenshot of a test piece with an area marked in red. That is the area I want to cut down to a level where my spindle wont hit it on deep cuts. I am using Vectric Aspire.


    Click image for larger version. 

Name:	Eagle Test.jpg 
Views:	2 
Size:	18.6 KB 
ID:	451725
    Last edited by dmyers1429; 11-06-2020 at 10:25 AM.

  2. #2
    Registered
    Join Date
    Dec 2003
    Posts
    751

    Re: Need a little help

    The attachment isn't showing.If my mental picture of your problem is correct,you may have to offset your cut vector on both sides by an amount equal to the radius of the part that is fouling.You can then use the pocket routine to remove the material within this zone to the depth that will make the cut feasible.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •