I do not know if Haas is advertising this... but to my understanding Haas has a new control which is presently shipping in Horizontals and Verticals ( not yet made it to the lathes). The new control is Linux based and not windows , (which can be a good thing). Haas has replaced the processor board and IOPCB board but more importantly just about totally eliminated access to the parameters. ... Even greatly limited the Haas Tech's access. Now the Haas tech needs to acquire a new key from the haas portal every two weeks which only narrowly broadens parameter access. Open your wallet is what this means, what was once a low cost of operation machine is gone. I'm thinking changing and encoder belt is going to be a $500 trip minimum. Information to know before buying a new mill. Any Ideas?