[DejanCNC7050]

Hello,
I need help connecting an NPN NC proximity switch to a NVEM V5
I found all the schematics and instructions but they are all for v2

On V2 there is 12V, INP 3 and the last pin is GND
Picture 1

on V 5 the pin arrangement is different
Picture 2

Does anyone have instructions and a wiring diagram but specifically for NVEM V5

Thanks in advance Dejan

[cncmakers001]

Hello,
I need help connecting an NPN NC proximity switch to a NVEM V5
I found all the schematics and instructions but they are all for v2

On V2 there is 12V, INP 3 and the last pin is GND
Picture 1

on V 5 the pin arrangement is different
Picture 2

Does anyone have instructions and a wiring diagram but specifically for NVEM V5

Thanks in advance Dejan

Maybe you can refer to this on YouTube.
https://www.youtube.com/watch?v=ET_1pbW2W58

[DejanCNC7050]

Thanks.

I watched that video too, it's about NVEM v2
As far as I've noticed, there are differences between v2 and v5.
I need a schematic and instructions for version 5

I made my own MPG and would like to connect it.

[RaderSidetrack]

The images missing from posts #1 and #3 at CNCZone are available here: https://en.industryarena.com/forum/nvem-v5--478011.html