I just replaced Spindle Motor on our PCV-60 and need to adjust Spindle Orientation stop position by
editing the Stop Position (M19). However,the Meldas 320M/330M instruction manual does not explain how to display
the Spindle parameter screen.

It states "Turning on SW5-1 on the SF-CA card makes the parameters set on this screen invalid".
I believe SF-CA refers to the Spindle Drive, but I can't locate the SW5-1 switch in the Drive.

My question is: What are the specific steps to Editing the Spindle Parameters on my 320M?.
Thank you.