I just acquired a Emco F1 CNC mill from a local school. It is in good condition, powers on and all the axis move.
I do not have any tool holders with it, where can I get them?
I do not have any operating manuals, where can I get them?
Thank you!
Printable View
I just acquired a Emco F1 CNC mill from a local school. It is in good condition, powers on and all the axis move.
I do not have any tool holders with it, where can I get them?
I do not have any operating manuals, where can I get them?
Thank you!
The manual is almost 10 megabytes what is your email address?
Jeff...
DNR has the tool holder pull stud.
http://tinyurl.com/ydqc5k4
http://www.dnrmfg.com/page3.htm
Give them a call.
I believe any 30 taper holder will work.
Jeff...
Jeff, Thanks for the info... [email protected]
Mark