I am using Cut2d to generate Gcode & DFX files. This happens in both KCam & Mach3. Can anyone tell me how to fix this?
Attachment 198162
Attachment 198152
I am using Cut2d to generate Gcode & DFX files. This happens in both KCam & Mach3. Can anyone tell me how to fix this?
Attachment 198162
Attachment 198152
Try slowing down, looks like you are losing a lot of steps -or cutting by hand.
Also make sure your using the correct post processor. If none of this works, provide more information. Machine info, speed, maybe even send the g-code.
Good Luck.
\Bill
Thanks Guys - I'll check it out