Printable View
Dear all
Out machine( witch is named by PG8, made by OKK and used Fanuc 160is controller), was mailfuntioned, there is an message":Please wait for NCBOOTis startup" and doing nothing else. I thing the NCBOOTis file was damaged. Is any one have this file to share or sale, or guide us how to disable Windows funtion on this contrller. The CF card( is mouted on A20B-3300-0330) maybe mailfuntion
The pictures:
Attachment 168108
Attachment 168109
Attachment 168110
Attachment 168111
Thanks.
Pretty sure nc boot is not a windows problem, that's usually waiting for boot signal from the fanuc main board. Should had a number on the led display on the main.
Dear untherthetire
Thanks for your reply.
The main is have not digital LEDs, it's only LEDs( as lighs up in attached picture), and it's show SVALM( that mean Servo Alarm, it's right?). Please guide us about this situation.
Thanks you so much.
Don't think I have manuals here for a 160i.
see attached :D
Did you resolve this issue. I'm also having the same problem