I am stuck We have come down to 3 machines that we are looking at
NV4000DCG APC (Mori Seiki), Kitamura Mycenter 2 APC, and a OKK VP600 APC
Can any tell me some advantages and disadvantages to all 3 of the machines.
Printable View
I am stuck We have come down to 3 machines that we are looking at
NV4000DCG APC (Mori Seiki), Kitamura Mycenter 2 APC, and a OKK VP600 APC
Can any tell me some advantages and disadvantages to all 3 of the machines.
We have just purchased a Mori Seiki NV5000 Alpha
20,000 Cat 40
Fanuc 18i with AI Nano (high speed contouring option, an absolute requirment for High feeds)
30 Tool changer (3 sec. chip to chip)
2 pallets (20 seconds chip to chip) 40" x 20" travel
For us, we need the 20k RPM because we do a lot of small dia carbide end mill work.
On the Mori the spindle is integral and there are no gears or belts.
This means that there are no consequencial surface finish results on our parts.
Believe it or not a gearbox (Kitamura) does not leave as good a finish as an inegral spindle (Mori).
Just for your reference, without the Fanuc AI Nano or HPCC option for high speed feed rate compensation you cannot feed "smooth" faster than 200 ipm.
The Mori has better acceleration than the Kitamura, I don't know about the OKK.
For both Spindle and Rapids. Technically they run .23 G servo motors, I'm not sure but that means that the servos can reach full speed acc/dec in .23 seconds for all 3 axis. The spindle takes no longer than 2 senconds to reach 20,000.
The Mori is the best IMO...
Beautiful workmanship.
I wish an American machine tool builder could compete.
Oh well,