Denford nova mill success (ish)

So I've recently been doing a mach3 conversion on my novamill. And finally got 3 axis motion. The spindle is hard wired to a switch at at reasonable rpm. Not my ideal setup but I can finally cut stuff. Posting because I'm excited. If anyone has a experience getting the spindle working correctly any shared knowledge would be greatly appreciated. https://uploads.tapatalk-cdn.com/201...209223da33.jpghttps://uploads.tapatalk-cdn.com/201...c5bc464395.jpg

Sent from my Pixel 2 using Tapatalk

Check out the Denford Site:
Novamill, first time in cnc (Mach conversion)

Novamill, first time in cnc (Mach conversion) - Denford Software & Machines

Also see my conversion of a NovaTurn:
NovaTurn Servo retrofit AMD Gizmosphere iBOB2 PCIe x1 - Denford Software & Machines

I hope to start my conversion of a Triac soon.

Iron-Man

Nice setup

Sent from my Pixel 2 using Tapatalk