1 Attachment(s)
TB6560 stepping motor driver and 5 AXIS CNC interface board
Dear friends, I am new at this and I am still trying to understand u lot of things so if anyone could help me I would appreciate it a lot.
I need to connect TB6560 driver to a 5 AXIS interface board but I don't fully understand the schemes i found on the internet.
Also is it necessary to get voltage (12V) on both driver and interface board or not, since the interface board is connected through USB and is recognized even without 12V. So if anyone is willing to draw the lines how to connect this or just maybe explain it to me I would be very grateful.
Attachment 267528
Re: TB6560 stepping motor driver and 5 AXIS CNC interface board
Based on what I see in the photo, there are two ways. One might work better than the other, so try both.
Method 1
Connect all three driver "+" pins to the interface 5v
Connect the three "-" pins to their proper pins on the interface
Method 2
Connect all three drive "-" pins to the interface ground
Connect the three drive "+" pins to their proper pins on the interface.
In both cases, don't forget to connect the usb so that there is power.
