Does anyone know how to peck tap on a HAAS?
Printable View
Does anyone know how to peck tap on a HAAS?
No but this might be worth a look
http://www.cnczone.com/forums/genera...d-tapping.html
Make sure you have rigid tapping parameter turned on. forget which one though, consult manual.
1/4-20 example
G43 G00 Z.2
S200 M5
G84 G98 Z-.1 R.2 F10.
G84 G98 Z-.2 R.2 F10.
G84 G98 Z-.3 R.2 F10.
G80
G00 (Next hole location)
I don't think you need all that repetition, as the parameters are modal.Quote:
Originally Posted by djr76
G43 G00 Z.2
S200 M5
G84 G98 Z-.1 R.2 F10.
Z-.2
Z-.3
G80
G00 (Next hole location)
Should work, too.
Yup, Beege is right. That's how we do it when we peck tap. Works fine.
Haas just put out video on this.
https://www.youtube.com/watch?v=yBK1MN_Q9J0
Hi,
I use ONECNCXR5 Mill Professional.
It has pecking tapping already built into the software.
Just pick either 2 level or 3 level peck tapping and fill in the desired peck depths and presto you have it all done for you automatically. If you look at the right side of the screens you will see where you fill in the desired pecking depths.
John
what a stupid way to peck tap, on fanuc you just add Q3 for example, it'll do same thing as in drilling cycle.
why can't it be done that way on haas in g84?
Quote:
Originally Posted by allenp
That's a good question. The Haas method seems a bit tedious.
C|