Is it possable to save your Work and Tool off-sets to a floppy so that they can be loaded back into the control at a later time ?
I see with this how to load them, is there a way to save them ?
Using a FANUC 16i-M control.
_
Printable View
Is it possable to save your Work and Tool off-sets to a floppy so that they can be loaded back into the control at a later time ?
I see with this how to load them, is there a way to save them ?
Using a FANUC 16i-M control.
_
Most of the fanuc "i" controls will have a [oprt] soft key on the offset page. You may have to press the right arrow soft key to find it. Once you press [oprt], press the right arrow soft key again until you see [punch]. press that, then execute.
Soft keys vary from control to control based on version and screen size.
Humm... just like saving a full program then ?
Glad it was not a snake :)
Thanks.