Asking for a fellow shop owner
Can you just pop off the Z axis motor with the 4 allen head bolts to get it rigged in place and would it be that easy?
Printable View
Asking for a fellow shop owner
Can you just pop off the Z axis motor with the 4 allen head bolts to get it rigged in place and would it be that easy?
He is getting a 4020 that might have a extended Z and putting into a area that has a 109" dock height. Wasnt the normal height 104"s and the extended Z something like 128"s?
Z motor is no problem to remove. 1 in 3 chance of getting it back on right for the CS as well. Easy to figure out but even easier to mark the coupling when removing.
There is also the cable carrier to remove up there (I think).
Where there is a will there is a way.
No problem
Doesnt removing the Z axis motor take more than the bolts though? Also wouldnt it cause the spindle to move around in shipping?
Have you considered the fact that the head will be lowered and blocked prior to shipping? Will that make it through his door?
Don
I have a 4020 with the extended Z (28"). The top of the encoder is right at 104" and the motor & energy chain is below this for shipping.Quote:
Originally Posted by carbidecraters
HTH,
Don
put the shipping pins into the z axis counter weight
Block the head
e-stop and power down
remove z axis motor, I put some tape on the motor and mount to line it all back up correct, zip tie the motor to something to keep it from flopping around, pocket the delrin coupler or whatever you have in there
remove the screws holding the gorilla track, front and rear cap screws and 4 phillips heads as I remember
drop the track
out you go.
Quote:
Originally Posted by donl517
Don thanks but I dont think the Z axis motor ever changes height. So the top of your Z axis is the same height as any other fadal...this would make sense. Now after enteding the z to tool change height it is then 128"s right?
Nervis I will tell him about the pins!
Sorry, I misunderstood your previous post, I was thinking about the spindle motor not the Z Axis motor.Quote:
Originally Posted by carbidecraters
At tool change height 128", with the extended Z, to the top of the spindle motor looks right.
As I said the Z Axis motor is right around 104".
HTH,
Don
Well I went and looked at the machine with him. It is a 1992 4020 with the 88 (Junk control IMO). It ran well on the high end but stalled the spindle on anything less than 500rpm and kept a 30-50% load on the spindle at anything less than 1000rpm...could be one of those little steel wheels that move the belts or keep tension. On the upside it did have a 10000rpm spindle and a spindle chiller but I think he is better off getting a machine with a better 88hs control and rigid tapping