Mach 3 post problem

Just wondering if anyone using mach 3 has run into this problem using Dolphin?

I imported my DXF, run the contour in the cam, no problem. Did the post using the mach 3 post processor. When i load it into my machine, I get an error message.."Radius from end of arc differs from radius from startline 20".

I'm thinking it's an issue with the X,Y arc offset but not sure..

In Mach3 go to Config > General Config and check that arc's are set to Incremental and then try that.

John S.

Quote:

---

Originally Posted by John S.

In Mach3 go to Config > General Config and check that arc's are set to Incremental and then try that.

John S.

---

Yes, IJ mode is set to incremental...