Few days ago got a fault on Hurco KM3P. Everything working fine, but when try to press PART PROGRAMMING button, screen goes blank, no responding from any buttons. Please any advise where to start the check. Thanks.
Printable View
Few days ago got a fault on Hurco KM3P. Everything working fine, but when try to press PART PROGRAMMING button, screen goes blank, no responding from any buttons. Please any advise where to start the check. Thanks.
Memory board, bad SRAM chip. One of the four flat chips next to the tall Dallas RAMs.
Hi Bloke, i change the SRAM chips, but it still the same:confused:
What else it could be?