Printable View
I have a 2009/2010 X4. Up to now it has worked without any issues. The past couple times I turned it on the blue LCD panel just blinks. I can shut down the main power wait 5 seconds and it may or may not repeat it. It has always turned on after two tries. Any advise? I dread the day I need it and it does not power up.
Regards,
Dennis
Anyone?
Today it took almost 4 tries before it turned on. I was hoping for some advise before I took the back off.
Syil Technical support. Any thoughts where to start or have you seen this issue / behavior before?
Dennis
The machine works with the LCD off?
Pablo
Thanks for your reply. It has not done it again since my post. I hope it was just those couple days. I do not use the mill everyday, so I post again if it does happen.
Where is Syil Support? Could use your insight and advise to what to do next time this happens again.
Thanks,
Dennis
looks like a loose connection or a defective power switch.
Pablo
With the power off, give all the crimped wire joints a gentle tug, one at a time.
Some probably need recrimping, or will after you've pulled too hard.
More than likely find the problem too. Don't even think of soldering any of the wires instead of crimping.