Vexta asm98-ac wired to pmdx-126

Hello all,

I am new to this group, and this is my first post, so please be gentle. I rebuilding a machine that I have with the PMDX-126, and I had purchased two linear rails on eBay that came with vexta asm98-ac motors already attached, so I thought I would just buy the matching drivers on there too, the vexta asd16a-c and see if these closed loop steppers would work out for me. Well, I just can't figure out how to wire these motors so that the pmdx-126 controller will drive the driver. Does anyone out there have any experience with the vexta drivers? Am I just barking up the wrong tree here?

Thanks in advance for any response for knowledge about this.

-Sam