Phoenix-EZ

I am looking for a program which I did not receive with this Lathe. The company went out of business and now my search is on. Magnum Tech built these units. it has a 36 in Between centers
and the tech spec is HQL-EZ [email protected] would be a big help.

Got a lathe through a school no programs but a computer that just plain died after about an hour,still trying to get a boot out of it.Older than dirt,hard drive connected to a interface. old wired battery.i will stay in touch as it progresses.
Iamthesnakeman

Can other programs be used to operate these lathes?

I work in a School that has a phoenix-ez we got it retroed at red-cam We can now use it with master cam. you will find them at red-cam.com they are good

Thanks for the info. Looking forward to getting this lathe going
Thanks
Iamthesnakeman