Printable View
Hi Guys,
I purchased a Turnkey Techno LC 3024 a few months back.
Love the desktop machine, but would like to replace the HSD non tool changing spindle with an ATC.
I'm assuming that you will be able to re-pin the spindle connection and find the connection
for the ATC air solenoid on the control board and you are good to go? Any one know if there is thread on this?
I looked at what ever is available on the Techno web with little luck. Thank you in advance, Otto
Otto,
We can help with this. We specialize in the original USA made Techno equipment.
There is a dedicated extra control board for the toolchangers on Techno machines (we have stock), and can provide the rest of the info you'll need to get it going. Contact us from the form on our website at Armor CNC or call the number listed there.
Regards
Eric
Thanks Eric,
I just left a message for you. Here is a couple pictures.
One is the Machine and new ATC spindle. The other is the I/O Riser card.
There are two connection points One is marked Spindle, one Coolant.
Coolant relay is simple enough.
Could this "Spindle" be the low voltage for the solonoid?
Hello,
I didn't see a message. How did you send it?
Spindle is not for the solenoid. That's for spindle speed control. You don't have the board for toolchanger sensors/solenoid control. You can get it from us if you like.
Eric,
left you a voice mail.