Mach3 DRO Question

I know this is simple but I cannot figure it out
I tried to find the center of my work but using edgefinder and locating to one side zero my DRO the jogging and locating to the other side. The selected the DRO and did the /2 function which gave me what I wanted the center of the ,2 numbers ....
So now the dumb part..
I have in the DRO the location I need to move my mill Too..
How do I do that...
I see nowhere to locate to a point in the DRO.

I would like to enter a number into DRO and locate to that number...

Ok.. lol how

Sent from my XT1635-01 using Tapatalk

You need to use the MDI for motion.

Quote:

---

Originally Posted by ger21

You need to use the MDI for motion.

---

So how to do that.. I am going to have to enter GCode to move it?

Sent from my XT1635-01 using Tapatalk

Quote:

---

Originally Posted by ger21

You need to use the MDI for motion.

---

So after thinking about it...

I assume I would do a G0 X and what number I got in the DRO...

Sent from my XT1635-01 using Tapatalk

Yes

Quote:

---

Originally Posted by ger21

Yes

---

Too bad they did not make it simple..lol

Sent from my XT1635-01 using Tapatalk

It is simple.

Quote:

---

Originally Posted by ger21

It is simple.

---

So how would you locate to center of a 2" solid

Sent from my XT1635-01 using Tapatalk