Printable View
Hello all,
I currently have built 2 servos to drive dc motors.
Also I can derive the dir/x/dir/y relative moves in an ascii file type.
My interest now is to find out what sofware packages you are using to
output this data to the UHU servo boards.
I should say that my project is essentially a plotter in nature.
Your opinions would be most welcome.
Regards GMS
I found some neat stuff for plotter related stuff at
this site.
http://www.luberth.com/plotter/ditwasplotter.htm
I remember some of the software used *.PLT files as input for the drivers.
Good Luck
Hello Torsten,
Got your reply ...Thank you.
Had a look at your suggestion.........at first glance the driver software is mainly for stepper motor systems....alas my system is DC motor driven with
1000 CPR encoders preceeded by 20:1 reduction
Regards GMS