PathPilot thread milling

Hi ,
I am trying to set up thread milling on my Tormach PCNC 1100 milling machine with the PathPilot control . When I go to conversational , thread milling and fill in all the pertinent info , I am lost as to how I get the program to post . I do not see any instructions directing me to go farther. I would appreciate any help .
Ernie

Did you figure this one out yet? The Post button is all the way to the left a little lower than the middle of the screen.

Quote:

---

Originally Posted by ErnieD

Hi ,
I am trying to set up thread milling on my Tormach PCNC 1100 milling machine with the PathPilot control . When I go to conversational , thread milling and fill in all the pertinent info , I am lost as to how I get the program to post . I do not see any instructions directing me to go farther. I would appreciate any help .
Ernie

---