Printable View
Using GRBL controller, everything works right when I send my files except the z axis, it simply does not respond, Manual commands work perfectly as well the axis controls by
keyboard. I am attaching the beginning of a file, maybe someone can see something I don't, thanx
G00 G90 G17 G21
M3 S24000
(Contour 0)
T1 M6
X-70.877 Y110.684
G01 Z-2. F150
X-70.842 F450
The x and y command responds, the z command does not.
Quote:
Originally Posted by bjwx2
Is the z axis setup for the right pins and ports (check)
Is the drive working (check, swap with a working axis.... This will also test the stepper motor)
Z axis works fine with manual control on keyboard and if I send a typed command in GRBL controller, does not respond to commands generated with artcam or abviewer? Just can't figure it out!
Any change if:
(rapid movement)
X-70.877 Y110.684
Z-2. F150
X-70.842 F450
OR
G00 X-70.877 Y110.684
G01 Z-2. F150
G01 X-70.842 F450
Remove everything else in this code, just run those lines.
hey
not sure if you're still on this, since its been a while.
but any chance you found a solution to this problem as I cant get my head around it :(