3 Attachment(s)
Rhinocam 2016 to mach3 mm loosing steps V carving embossing
Hi everybody, I'm writing with the hope somebody would have encountered the same problem then me...
I'm using rhinocam with mach3.
My machine i correctly setup, motor tuning and acceleration is fine.
If I try to run a simple square in 2D with defined dimension it works perfectly.
Problem starts when I'm doing V-carving with a 45° V bit.
Even thought the G-code seems to be correct and the preview in the cam software is exact the cut is different.
I seems that I'm loosing steps at the end of my code ruining my piece of work :)
In the attached images you can better see what's my problem.
We can clearly see what's happening at the upper right corner that stays rounded. The V bit exit to early...
G-Code:
Lines comming from the exterieur square supposed to be cut by the v-mill
G00 G49 G40.1 G17 G80 G50 G90
G21
(V-Carving)
M6 T1
M03 S20000
G00 Z10.0000
X284.9980 Y15.0020
G01 Z-5.0000 F103.0
Y184.9980 F300.0
X289.9980 Y189.9980 Z0.0000
X284.9980 Y184.9980 Z-5.0000
X15.0020
X10.0020 Y189.9980 Z0.0000
X15.0020 Y184.9980 Z-5.0000
Y15.0020
X10.0020 Y10.0020 Z0.0000
X15.0020 Y15.0020 Z-5.0000
X284.9980
X289.9980 Y10.0020 Z0.0000
X284.9980 Y15.0020 Z-5.0000
G00 Z10.0000
M5 M9
M30
Lines at the same moment from the entire code
G00
X284.9980 Y15.0020
G01 Z-5.0000 F103.0
Y184.9980 F300.0
X289.9980 Y189.9980 Z0.0000
X284.9980 Y184.9980 Z-5.0000
X15.0020
X10.0020 Y189.9980 Z0.0000
X15.0020 Y184.9980 Z-5.0000
Y15.0020
X10.0020 Y10.0020 Z0.0000
X15.0020 Y15.0020 Z-5.0000
X284.9980
X289.9980 Y10.0020 Z0.0000
X284.9980 Y15.0020 Z-5.0000
Hopefully somebody had the same problem previously and could help me to figure out.
Best regards
Lucas
Re: Rhinocam 2016 to mach3 mm loosing steps V carving embossing
Acceleration that works fine for 2D work may be too high for 3D and V Carving.
Reduce your acceleration by 50%, and see if it fixes the issue.
Re: Rhinocam 2016 to mach3 mm loosing steps V carving embossing
Thanks a lot for replying i'm gonna try that now
Re: Rhinocam 2016 to mach3 mm loosing steps V carving embossing
THX great advice, I tried few times by decreasing the acceleration and it worked perfectly, I had to go down from 400 to 50.