OKUMA MU400VA OSP-P200 MH Large and heavy tools
Hello,
Machine is intermittently dropping the same tool. I believe the tool would fall under the Large and heavy category. Does anyone know how to designate a tool as heavy on an Okuma P200 controller? the machine is listed below;
Okuma
MU400VA
Controller OSP-P200 MH
Your input is much appreciated
Ray
Re: OKUMA MU400VA OSP-P200 MH Large and heavy tools
hy :)
... heavy atribute reduces arm swing speed
... large atribute checks for atc neighbour pots to be empty
* thus, neither is related to spindle clamping
does the weight of your toolholder+tool<maximum allowed for your machine ( values should be listed inside the operation&maintenance manual, and also inside machine catalogue ) ? if yes, then maybe :
... your spindle clamping power has reduced; broken elements maybe ?
... your toolholder does not make proper contact with the spindle taper
... pulstud needs to be replaced
... there is a lack of balance, even if rpm is low
if i understood right, that the tool does drop/fly-off, i would recomand checking spindle's retention force, taper contact and claws condition ( those that grip the pullstud ) / kindly :)
Re: OKUMA MU400VA OSP-P200 MH Large and heavy tools
Quote:
Originally Posted by
Raylawando9
Hello,
Machine is intermittently dropping the same tool. I believe the tool would fall under the Large and heavy category. Does anyone know how to designate a tool as heavy on an Okuma P200 controller? the machine is listed below;
Okuma
MU400VA
Controller OSP-P200 MH
Your input is much appreciated
Ray
Max 10kg
Sent from my iPhone using Tapatalk
Re: OKUMA MU400VA OSP-P200 MH Large and heavy tools
Try SET 5,L when setting a large tool #5. That should slow it down. If adjacent tools need to be dummy, then use ,D. If clearing use * to remove setting. I think ,H may also work for heavy tool.