Re: Toyoda representative here if you have any questions
There is a switch inside the main panel that when flipped it step by step when you command multiple M06 in MDI mode. Each M06 will do a step in the tool change process. So put many M06 in MDI program page each followed by EOB. Put machine in single block mode and flip switch. Each time you press cycle start it will change the tool block by block.
Re: Toyoda representative here if you have any questions
Hello Anthony, are you still checking the forum? I have a thread going about losing my zero positions on a FA-400 as well getting a AL94 alarm. I'm getting a little desperate as I'm not getting much support from Toyoda, and if I don't get this machine going soon, I will lose the job I bought it for. Any help much appreciated.
Thanks, John
Re: Toyoda representative here if you have any questions
Dear All
I need urgent help!!
We recently bought a used Toyoda FA 550 with fanuc 15m with alpha drives from UK.
When we power on this machine the system is not getting ready it shows this message:
F15M14 A0C20
?
I P L
1. DUMP MEMORY
2. SET FILE
3. CLEAR FILE
4. FILE
5. SETTING
6. END IPL
?
Can anyone help how to resolve this problem.
need an urgent help and response.
Thnx
vishal jain
Re: Toyoda representative here if you have any questions
Were you able to resolve this issue? I am having a similar situation.
Re: Toyoda representative here if you have any questions
Hello Anthony, we are having a Toyoda GCH32B camshaft grinder yom 1998. Can you please suggest what is the maximum Feed rate we can use for the Truing operation.
Also is there a procedure to be followed when we replace the MCU card ? If so, kindly share.
Your help highly appreciated.