Syil CNC SX3 spindle interface board
Hi all,
I have a Syil SX3 cnc mill and am wondering if anyone come across a schematic for the spindle interface? board, the "cheater" board that feeds spindle driver board, switches modes from cnc to manual and controls appliance relays? I want to put together a complete set of drawings but can't seem to find this one. I have the schematics for the BOB, spindle driver w/daughter board (Thanks Neil) and the display board and it would be nice to complete the set!
Thx, Dave
Re: Syil CNC SX3 spindle interface board
Hi Dave,
Slightly off topic however
Whatever you do do not go to Arceurotrade and admit that you have a Syil machine for spares. I burnt out a power board and the touch pad board when the depth gauge caused a short. As I could not find spares I decided to go over to Sieg boards. Arceurotrade knew I had a Syil machine from past correspondence and refused to sell them and cancelled my payment with no valid explanation. They do sell compatible parts of value just don't mention Syil. Answer was to go direct to China and buy direct from their supplier. The wait is inconvenient and they have lost any future trade from me!
Re: Syil CNC SX3 spindle interface board
Hi there to make amends for the rant.
I have the drawing you require but it is too large to transfer. Shrunk down it is unreadable.
Is there anyway to PM me.
Bob
Re: Syil CNC SX3 spindle interface board
Thanks Bob, I'll PM you.
Dave
Re: Syil CNC SX3 spindle interface board
Quote:
Originally Posted by
BobFitch
Hi there to make amends for the rant.
I have the drawing you require but it is too large to transfer. Shrunk down it is unreadable.
Is there anyway to PM me.
Bob
Hi Bob, it appears your PM is set to off. If you enable it I will PM you about theSyil board schem.
Dave
Re: Syil CNC SX3 spindle interface board
ik had ook graag een schema van een sx3
[email protected]