-
Tool Holders
What kind of tool holder does the Hurco use? I have a Sumitomo 3 inch face mill and it looks like it takes a shank that fits down into it with a slot milled in so that the "arms" on the shank prevent it from spinning in place. A bolt comes up from the underside and is threaded into the shank to hold everything in place. I just have no clue what to ask for or where to go online to look at it. Any help would be appreciated.
Pat:confused:
-
What model Hurco? You're likly going to have either a Cat 40 spindle or a BT 40 spindle. You need to know. You'll also need the correct pull stud for the holder. http://www.maritool.com/ is a good source for holders. You'll need whats called a shell mill holder for the correct spindle taper.
-
Hurco tool holder
It is a KM-3P knee mill with the qc 200 collet system.
Pat
-
You've got the Erickson Qwik Switch 200 nose. You need a KS200 shell mill holder. One source of some Erickson stuff is below. Google around a bit and you might find what you're looking for.
http://www.tools-n-gizmos.com/store/...es&user4=KS200
-
Thank You!
I appreciate your help.
Pat
:)
-
I don't have a km-3p but I do have a Kmb1 with the quick switch 200. My machine does not have the power or rigidity to run a 3" face mill with any kind of efficiency. Just wanted to warn you before you spent the money on a tool holder.
Jim
-
Actually you have a Universal Kwik Switch 200. The KM3p has more than enough power but watch the rigidity.
You can purchase these at Jensen & Assoc, Jeff Jensen 770-346-8858. GA
Tell him Buddy at Accurate Machine recommended him.