4 Attachment(s)
Mastercam 2022 2d dynamic mill on mach3
Hi
I have peoblem milling via 2d dynamic milling.
I create toolpath for 2d dynamic mill while selecting default mach3 3 axis mill machine and it simulates well in mastercam then i generate nc file. After that i load that file in mach3 it shows on display strangely and goes out from table display
I haven't that problem in 2d countour it works and post correctly
Sending you pics in table display mood of mach3
Can someone tell me what is the problem
Re: Mastercam 2022 2d dynamic mill on mach3
Probably just the way the Mach3 controller is displaying I and J locations somewhere off the table. This is used for the math of the toolpath but not used for the actual toolpath. Can you send a sample of the G code. I can run it through my simulator.
Re: Mastercam 2022 2d dynamic mill on mach3
Hi,
Mach3 uses incremental arc notation whereas you post is using absolute arc notation. Change the setting in the post and it will work fine.
Craig