We recently bought a used CNC with a 180i-M control. When in G21 mode the increments are in mm as expected, but when in G20 mode the increments are changed to cm instead of inches? What parameters likely need changed to enable G20inch mode?
Printable View
We recently bought a used CNC with a 180i-M control. When in G21 mode the increments are in mm as expected, but when in G20 mode the increments are changed to cm instead of inches? What parameters likely need changed to enable G20inch mode?
Use G21 is okay, no need to use G20.Quote:
Originally Posted by Todd Zuercher