Printable View
hi
i have problem with Hurco ,sometimes works 1 day ,sometimes works 5 days,sometime works couple hours ,
today i turn on machine works couple hours and receive on the display servo Y faulty on the monitor,in cabinet on the servo Y is AL10,sometimes i get faulty X axis and alarm AL10 on servo ,one time i receive faulty Z axis and AL10
please helpAttachment 436588Attachment 436596
Check what al10 means in servo catalog
[email protected]
+37060022992
I think it's an over temp alarm. Usually this means that the fan inside the servo has failed and the heat sink is overheating. If you are getting this on multiple axes then try opening up the cabinet a crank and see if better airflow through the electrical cabinet makes it go away. The actual alarm may be listed as an over current alarm, and if its not the fan, then it can be tested by swapping all of the wiring from the x to the y axis and running the machine. If the error swaps to the y axis then its either the motor or cables from the servo amp to the motor. If it stays on the x axis then you need a new servo or need to rebuild the one you have.