Problem with Brother Wire EDM
I just bought Brother HS3100 wire EDM machine at auction and after powering it up everything was fine for few days. Than one morning I turned it on and the screen and the keyboard were dead.(except green ON and red OFF lights).The rest of the machine was ON. (fans and all the electronics inside the machine were running). I checked all the fuses and I found one (3Amp fast glass) blown inside the control. And now, after replacing that fuse when I try to turn on the machine , it powers up but after 5 seconds it turns itself off. Same thing happens when I disconnect CRT monitor.(no difference) Is it possible that the monitor is bad ,and there is no confirmation to control board that the monitor is working and that's why machine is shutting off ? Any idea? When I remove the replaced fuse machine powers up but the keybord and monitor are still not working. Thanks for any response! One more thing. This machine is wired for 240 V. It has other 4 options (200, 208, 220 and 230 V) In my place voltage varies from 205 to 215 V) Would that be a problem?
Re: Problem with Brother Wire EDM
Quote:
Originally Posted by
roysol
The electrical variance could well be enough to cause problems. On most machines they want it within 5%, yours is out of that range. Another common problem on used machines is the battery that backs up the operating system is dead. When you power it off it loses it's memory, and you have to re-load the software and all the parameters.
I never shut my machines off, the control, servos, and pumps are constantly running.
Cheers!
Roy Solomon
Roy,Do you the procedure for reloading software and parameters on the Brother HS 3100 ?
1 Attachment(s)
Re: Problem with Brother Wire EDM
Brother HS 3100
Does any one Know the MFG and a part number for the wire feed motor #2.
The motor has a sticker from Brother
I have this part number from Charmliies
M48B-Z25726001
http://www.cnczone.com/forums/attach...d=358480&stc=1
Re: Problem with Brother Wire EDM
I'm in a big problem
I want an old machine manual (Brother HS-3100 wire cut machine)
Please if you know any source I can find it from
Re: Problem with Brother Wire EDM
hi dude, did you find the manual?