moving the cambam tool paths
new user needs help with cambam - I have just about mastered putting tool paths on to profiles but im having trouble moving tool paths where cambam put them . is this even possible to move? eg on a circle it puts the lead in at the top instead of the bottom which produces more travel time and the next profile the same and so on.
I have looked for tutorials but not much luck checked the cambam documents and they are not much help either.
thanks for a help
Re: moving the cambam tool paths
Let's say that you have a series of circles to cut out. CamBam allows you to set the start point of the series using the Start Point and clicking on the layout. But if all of the circles are in the same MOP, then CamBam will choose what it considers the best path for the rest which is not always the most efficient IMHO. The way around this is to put each circle in it's own MOP and set the start point for each. You can copy and paste the MOPs so this is pretty easy to do.
On the other hand, for $149, CamBam does a fine job.:) You could buy a seat of MasterCam for around $8500:eek: and it still does stupid stuff.
Re: moving the cambam tool paths
Why don't you post this on CamBam forum. I'm sure, the people who know it will be able and happy to help you with your questions.
CamBam - Index
Re: moving the cambam tool paths
In CamBam, when you create a profile operation, you have to choose Inside or Outside. Look at the second line from the top in the MOP setup.