DX32 Bridgeport Torq Cut 22 Mastercam Machine Post
Does anyone have one of these that works?
The one on the Mastercam website post G-code inverted/corrupted.
e.g. - drilling canned cycle:
N10 G87 X2.047 Y.94 Z1.4627 Z.15 Z.1 F3.3
N20 X5.922
N30 G80
N40 G75 G90
N50 G0 X10. Y10. T3 M06
Machine makes the drilling motion with the previous tool then changes to the drill (T3)
No coolant controls get posted (M8/M9)
the X10. Y10. puts set the "out of limits" alarms
Any assistance or guidance would be appreciated.
Re: DX32 Bridgeport Torq Cut 22 Mastercam Machine Post
DX32user.
In Bridgeport Machines world all M codes must be on a seperate line...
N100 G0 X1.0
N110 T1M6
N120 S1000 M3
N130 G0 X2.0
You can check the G87 syntax in the programmers manual.
Bart
Re: DX32 Bridgeport Torq Cut 22 Mastercam Machine Post
Appreciate the info, bptcontrols.
Would you happen to have a machine post processor for Mastercam for these machines that has been proven or close to it?
Re: DX32 Bridgeport Torq Cut 22 Mastercam Machine Post
Quote:
Originally Posted by
DX32User
Appreciate the info, bptcontrols.
Would you happen to have a machine post processor for Mastercam for these machines that has been proven or close to it?
Hi, I wondering if you ended up finding a post processor for mastercam? I'm looking for the same.