-
Can anyone help us?
I'd appreciate it if some one could give us some EDM data.We're going to make some cavities in aluminum, .75x.375, Depth 2.5 inches.
We are completely new to this.
Machine is a Hurco EDM.
We need:
On Time
Off Time
Amp.
Work time
Up Time
Voltage
to get it done as fast and as accurate as possible.
Do you have to do a rough run before finishing the hole?
Thanks in advance.:withstupi
-
I would rough then semi finish and finish use negitive polarity... is machine cnc/ what type of control...the negitive polarity will burn very fast but will wear trodes fast....
-
Thanks.
It's a TRM-39, manual in X ,Y and the control is a Futaba.
-
How about these values?
On Time-050
Off Time-015
Amp.-15.0
Work time-05
Up Time-15
Voltage-80
It took me 25 min. to get a .5 depth.
With predrilled holes,16 min.
Good or Bad?