I’d like to try to find the model and any information about her thank you!
Printable View
I’d like to try to find the model and any information about her thank you!
Eric,
This is a gantry 027 or 130 or similar, the number varies based on the working size of the machine.
Were you able to get a hold of the pc/control card?
Regards,
Eric
I was not im looking at getting one from armor cncQuote:
Originally Posted by ericscottf
Also the entire base measures a hair under 5’x6’ so I’m guessing maybe it’s the 130?Quote:
Originally Posted by ericscottf
I was gifted a similar machine but without the PC Card. I decided to fit new steppers and UCCNC control after seeing the price to replace the card. I still have the servo motors, wiring harness and drivers but didn't find a control solution within my budget at the time. There were solutions to the +-10v analog control without the original PC but I didn't have the confidence to spend and try them out. Also I didn't know for sure if all my drivers were still in working order anyways. Hope you find what you need!
Cheers from British Columbia
Wasn't this a forerunner to the Techno-Isel machines? I believe there are others out there that may still offer support. Good luck in your search.
Hello GizmoCNCQuote:
Originally Posted by Gizmocnc
Would you be interested in parting with any motor and cable sets from the old set. I'm looking for Electrocraft E 242 or E243 servos.
If so you can PM me.
ShopWorks07
Shopworks07,Quote:
Originally Posted by ShopWorks07
We have those motors if you can't find them elsewhere. Let me know.
Also,fyi,242 and 243 are not necessarily interchangeable, be careful with what you do, let me know if you need any help identifying which you should be using where.
Regards
Eric