Tornado 300 Duplomatic Turret
Hi,
We have a Colchester Tornado 300 with a 12 Tool Duplomatic Turret, with Fanuc O-T B.
It was running fine until last week.
The turret continued past it's designated tool, clicking as if the pin hadn't fired enough and flagged a "Turret overheat, turret unclamped, turret solenoid, 401 servo alarm"
We managed to get it going by backing off the solenoid capscrews, so the solenoid was sticking out by a few millimeteres. This got us away enough to complete the job.
We took the solenoid out and dismantled it, noticed that the insluation was a bit wet/slimey.
We've since replaced the solenoid with a brand new one, but are getting "1019 turret solenoid" errors.
If we back the solenoid off the turret rotates and locks in.
Is this a problem with the locking pin sensor?
Need this sorted asap, got a lot of work for this machine and can't wait for an engineer to "fit me in" in a few weeks time..... HELP!
Yarpo.
Re: Tornado 300 Duplomatic Turret
Hola tengo un torno Clausing Colchester STORM CNC 300, con fallas en el cambio de herramientas en la torreta DUPLOMATIC BSA200/ Series 20. Hace algunos cambios con pero después de 10 cambios de herramientas este falla, no bloquea la torreta. Ya seguí el procedimiento de ajuste pero aún a si sigue la falla la torreta tiene exceso de vibración al hacer el cambió, cuenta con 2 amortiguadores hidráulicos que no he cambiado, por qué no los encuentro. Me podrían apoyar un poco con esta falla?.
Saludos.
Re: Tornado 300 Duplomatic Turret
Yo tengo el mismo problema, cambié los shock absorbe y ya me hace cambios, pero solo en un sentido, en sentido anti horario. Cuando regresa el giro en sentido horario me falla de nuevo.
Alguien me podrá ayudar?
Re: Tornado 300 Duplomatic Turret
Check your sensors if they are OK I suspect you have a relay fault