Originally Posted by
matthewomeara
Sorry, I'm using version X4. The machine I have is an OMNI 1530 linear ATC router with the Syntec 6MB controller. I ended up switching to the Generic Fanuc 3x post processor and figured out how to hack it to produce the GCODE that I found in the sample program that came pre-loaded on the Syntec controller.
I'm assuming the sample code is just fine, but while I've got the thread going I'm curious to know what the GCODE should be for the Header, Tool Change, and the end of program. This is what I have:
Start of program:
G90 G49 G40 G80 G54
G53 Z0
G0 X0.0000 Y0.0000
Tool change:
M5
G53 Z0 (I think this is redundant, but can't hurt)
M6 T1
M3 S16000 (I haven't configured speeds yet)
End of program:
M5
G53 Z0
G0 X0.0000 Y0.0000
M30
Does that all seem correct?