Re: Milltronics 3d program
Why do you even need the p program? Where are you transferring from?
Sent from my SM-N960U using Tapatalk
Re: Milltronics 3d program
Are you using fastcam or cadcam?
Sent from my SM-N960U using Tapatalk
Re: Milltronics 3d program
Quote:
Originally Posted by
russellrought
I am transferring from a computer via floppy disk. The control won't alow me to load from the floppy without an o and p file.
Milltronics vm24 centurion 6
Do you have full dos names turned on in parameters. You should be able to load a .tap from your cad cam.
Sent from my SM-N960U using Tapatalk
Re: Milltronics 3d program
Go into parameters enter the password, I think it is under control make sure "use full dos names" is set to yes. No dnc necessary.
Sent from my SM-N960U using Tapatalk
Re: Milltronics 3d program
Hi Russell, There are several ways to load programs. how you load and run it will depend on the available memory (Parts storage) RAM, . If the control has been updated to a Single Board Computer ( SBC) etc,
If it is a SBC I have a program I wrote to zip up about a 4.5MB CadCam file Zip it up and be able to UNZIP directly into the control thru the floppy drive or one of my USB floppy emulator drives This works on SBC and controls that are booting from a hard drive.
From there, a couple of other option become available,
I can even update your control to use a thumb drive, This is a full 2GB "hot swappable" thumb drive system that works in DOS. I call it my Super SBC control update.
Give me a call
sportybob
952-288-6340