2 Attachment(s)
XHC MACH3 MKS V control board issue
Hi all,
I've purchased a China CNC 6040 with XHC mks v control board. I'm trying to setup a solenoid to control cooling but unfortunately so far despite lots of reading I've been unsuccessful.
I'm using Mach 3, which already has flood/ mist control assigned to output 4. This is ideal I thought, wire up the relay to the control boards 5V output then use output 4 to turn the relay on/off.
However when I use the M7 gcode to turn the mist coolant on nothing happens, I've measured the voltage and on it measures -0.5V and off 0V.
I'm completely lost as to why the voltage on output 4 is not high enough to activate a relay.
Does anyone have an idea as to what is wrong or anything else I should do to get coolant running?
Please see the attachment images
Many Thanks
Colin
Re: XHC MACH3 MKS V control board issue
When I did mine on my different bob it didn't work either. Turned out my control board was a negative output to axis. So I had to wire my SSD positive to my 5v+ supply and my negative - to the axis pin. Can't remember off hand whether mach then had to be active high or low.
No guarantees cable swap rounds will work for you though.
Re: XHC MACH3 MKS V control board issue
Are you sure port 1 pin 3 is the right configuration?
Re: XHC MACH3 MKS V control board issue
Thanks Guys,
In the end I got it to work using a 24V power supply and 24V relay. I ran 24V between Output 4 and 0V outputs and was able to toggle the relay on/off using the M7 & M9 commands in mach 3.
No idea if its possible to use the 5V outputs.
I just need to configure the E stop now, which for some reason does nothing.