Help needs in haidenhain TNC 151
Hi
I have problem in TNC 151. Machine axis goes to reference point normal but after reference it vibrates heavy and gross positioning error.
Any kind of help appreciate.
M. Shabbir Mughal
Re: Help needs in haidenhain TNC 151
Probably tach needs adjusting
what machine is it on with which servo drives?
Re: Help needs in haidenhain TNC 151
Quote:
Originally Posted by
gus
Probably tach needs adjusting
what machine is it on with which servo drives?
all axis.
if i change control then normal.
Re: Help needs in haidenhain TNC 151
You response makes no sense
No one can help if you do no give information
Re: Help needs in haidenhain TNC 151
Quote:
Originally Posted by
gus
You response makes no sense
No one can help if you do no give information
hi
what type info u need?
all axis have huge vibration.
when going to ref its normal. after ref complete motor vibrate and gross positioning d error.
i checked all axis separately.
Re: Help needs in haidenhain TNC 151
SO repeat yourself without answering the questions asked
What machine and what servo amps
When homing the control just puts out a set voltage to move the axis in a direction. It does not close the positioning loop until it hits the trip dog for the axis position. Your machine cannot control the position loop, tach adjustment, gain adjustment,
Start by answering the questions
Also, has this machine run for you before,?
Did you lose the parameters?
Re: Help needs in haidenhain TNC 151
Quote:
Originally Posted by
gus
SO repeat yourself without answering the questions asked
What machine and what servo amps
When homing the control just puts out a set voltage to move the axis in a direction. It does not close the positioning loop until it hits the trip dog for the axis position. Your machine cannot control the position loop, tach adjustment, gain adjustment,
Start by answering the questions
Also, has this machine run for you before,?
Did you lose the parameters?
hi
yes i know all that for this controller. when it goes to close loop it will in problem. i have checked the teco and adjusted but same . and also set the gain in parameter n on drive. but same
tr one more tomorrow then update here the results.
Re: Help needs in haidenhain TNC 151
Quote:
Originally Posted by
moghul
hi
yes i know all that for this controller. when it goes to close loop it will in problem. i have checked the teco and adjusted but same . and also set the gain in parameter n on drive. but same
tr one more tomorrow then update here the results.
how to resolve that?
i have thesame problem. but no have original parametrs.
Re: Help needs in haidenhain TNC 151
I realize both the posters here that English is not your first language
But
What machine?
This is minimum information
If you cannot communicate, take pictures
Parameters are the only thing that tells the control how to run, whether it is a toaster or a color TV or a vertical mill. They are not optional, the machine cannot run at all without the correct parameters